302001 Hot Rod Fab Bundle #1, 2 qty 54 5/8 v-track, 6 conc and 2 ecc mtg kits

$198.48
(No reviews yet) Write a Review
SKU:
302001
Condition:
New
Country of Manufacture:
United States
Model:
VRD-2
Country/Region of Manufacture:
United States
Type:
Square or Profile Rail
MPN:
VRD-2
Brand:
IMService

New

Hot Rod Fab Bundle #1 Consisting of the following:

2 each 54 5/8 #2 V-track Steel Drilled 2*$66.95 = $133.90
6 each #2 concentric ( fixed ) v-wheel mtg kit, 6 * $7.60 = $45.60
2 each #2 eccentric ( adjustable ) V-wheel mtg kit, 2 * $9.49 = $18.98

Total = $198.48

 
Ident Brand Description Length Used in:
302040-54.62 Made in USA Pre-drilled, #2 Edge hardened steel V-track for linear slides Use with #2 V-groove bearings (3/8 bore).  54 5/8 inches CNC machine slides

This is new stock.  Comes oiled and sealed in plastic.

 

This listing is a length of V-track (54 5/8 inch).  The material is steel with an induction hardened 90 degree V on the top.  Each track is pre-drilled with the first hole starting at .31 inch from the right side of the track.  The 13/64 (.203) drilled holes are clearance for a #10 screw ( 10-32 or 10-24).  The hardened V-track will hold up for years of service using hardened #2 V-wheels.

The material is hardened so it is not recommended to cut with a band saw.  An abrasive chop saw or cutoff disk in a hand held tool ( like a Dremel) will work fine if you need to cut to a different length.  We screw two lengths to both sides of a 3/8 thick x 3" wide cold rolled steel length or an extruded aluminum rectangle to form a slide mount for either our 4" or 6" Z-slides.  Typical accuracy of the width of a cold rolled steel or Extruded aluminum rectangle is about .001 inch per foot.  The resulting assembly yields an excellent structure on which to build a CNC router, plasma, laser, or other table based CNC machine.  Using this material on our desktop CNC routers we typically have .002-.004 total variation per foot.  An alternative to using two opposed V-tracks is to use a V-wheel on top and a cam follower on the bottom of a single v-track.  The cam follower is slightly pre-loaded to prevent lifting of the V-roller from the track.  This concept is used on our moving table machines.

Layout Drawings: